Trident-TopHat

A Repository of the Mod (Trident TopHat for the Voron Trident)

What is the purpose of this mod?

I designed this mod because I run an EBB36 (CANBus) on my Stealthburner Toolhead. I utilize cable glands for strain relief going from my tool head to the A Motor mounts. This mod is to give a little extra head room for anyone who deals with a similar issue.

BOM

Extrusions:

        8 "A" Extrusions from you printers BOM. Sizes Listed Below

        250mm: 370mm
        300mm: 420mm
        350mm: 470mm
        
        4 150mm (or however tall you wish to make it) 2020 extrusions with holes for Blind Joints

Hardware:

      4 M5x20 BHCS
      24 M5x16 BHCS
      2 M5x50 BHCS
      2 M5 Nylock Nuts
      12 M5 T-Nuts

      36 M3x8 SHCS (These are for the Pannel Clips, Reuse the ones from your top panel for the TopHat)
      36 M3 T-Nuts
      4 acrylic Panels for all 4 sides (Another thing that is kit dependent is th Width of these)
      
      # WxH
      
      250mm: 383mm x 123.50mm
      300mm: 433mm x 123.50mm
      350mm: 483mm x 123.50mm
      
      
      3mm Foam tape 

Printed Parts:

           14 Corner Panel Clips
           8 Midspan Panel Clips

           (Would recommend to print these with supports for now until I do designed supports)
           
           1 Trident TopHat A Hinge Top
           1 Trident TopHat B Hinge Top
           1 Trident TopHat A Hinge Bottom
           1 Trident TopHat B Hinge Bottom

The kit that I will be using, as I dont have one made yet, will be custom done by @kbreezy24 from KB3D (link will be down below to the web store)

https://kb-3d.com/store/