Generac Evo2 over Serial IP

[Twilliamson3]

Checklist

• I made sure that there are no existing issues or discussions - open issues,closed issues,open discussion, closed discussion - which may answer my question or that I could contribute my information to.
• I have read the Known Issues Wiki Page and my question / issue is not listed.
• I have provided the version of the software and the operating system in my post.
• If I have an issue with genmon not communicating with the controller, I have read and followed the serial troubleshooting guide.
• I have included the generator make and model in my submission.

Version

1.19.08

Have you submitted your log files from the About page? Note that outbound email must be working for logs to be submitted.

I have submitted logs

What is/are your question(s)?

Trying to get a Generac Evo 2 Controller working with a Serial over Ethernet to a Debian VM running Genmon. I have my converter setup as following.

and Genmon setup like this.

What am i missing?

Additional information

No response

[Twilliamson3]

Patience. I was missing Patient . Sorry for the Noise.

[jgyates]

no worries. I am glad it is working for you.