emscope documentation should describe connection to targets used

[gcohler]

For example:

Using Nordic Power Profiler II (PPK2) with TI LP-EM-CC2340R5 LaunchPad

Using the PPK2's supplied four-wire cable with the black wires on ground, the red wire on Vin and the brown wire on Vout:

• Connect the PPK2's P1-2 Vout signal to the LaunchPad's P1-1 (three-pin header) 3V3 pin
• Connect either PPK2 P1-1 Gnd signal to the LaunchPad's P1-2 Gnd pin
• Connect the PPK2's J2 USB datapower connector to your PC for data collection via emscope
• Operate the emscope grab command in (default) --source-mode with --voltage between 2.2 and 3.3 (default)

Schematics

Download the schematics for the two boards from the URLs below:

• PPK2: https://nsscprodmedia.blob.core.windows.net/prod/software-and-other-downloads/dev-kits/power-profiler-kit-ii/pca63100-power-profiler-kit-ii---hw-files---1_0_1.zip
• LaunchPad: https://www.ti.com/lit/zip/SWRC381

Examples emscope grab commands

• emscope grab --ppk2 will use the PPK2 in source-mode with 3.3V supplied to the LaunchPad
• emscope grab --ppk2 --voltage 2.2 will use the PPK2 in source-mode with 2.2V supplied to the LaunchPad

[biosbob]

we would like to keep this level of detail out of emscope itself -- and push it into the actual capture repo(s).... there is clearly a lot of common material in describing any capture; and we're looking for the handle this in a scalable manner....

[gcohler]

It's up to you. I would put instructions for using emscope in emscope.