Dear Workbench development team,
First of all, I would like to express my sincere gratitude to you and your team for developing Connectome Workbench. It has been an incredibly helpful tool for my research.
My problem:
volume image in MATLAB (SPM)
volume image in Connectome Workbench
I am using Workbench 2.1.0 on Windows 11. After loading a volume overlay (my CAP statistical map), I see strong checkerboard artifacts in the scalp region.
I have checked the same volume image in MATLAB (SPM) , and it displays normally without any artifacts. This led me to suspect that the issue might be related to Workbench's display settings.
I would like to change the interpolation method – I suspect it is currently set to nearest neighbor, and I would like to change it to Trilinear or Cubic interpolation to smooth the image and remove the artifacts.
However, I have been unable to find where to adjust the interpolation settings in Workbench.
What I would like to ask:
Where are the interpolation settings located in Workbench 2.1.0? Could you provide a step-by-step guide on how to access and change them?
If you have any other guesses about what might be causing these artifacts (unrelated to interpolation), I would greatly appreciate any suggestions or advice.
Thank you very much for your time and for developing such a valuable tool.
Dear Workbench development team,
First of all, I would like to express my sincere gratitude to you and your team for developing Connectome Workbench. It has been an incredibly helpful tool for my research.
My problem:
I am using Workbench 2.1.0 on Windows 11. After loading a volume overlay (my CAP statistical map), I see strong checkerboard artifacts in the scalp region.
I have checked the same volume image in MATLAB (SPM) , and it displays normally without any artifacts. This led me to suspect that the issue might be related to Workbench's display settings.
I would like to change the interpolation method – I suspect it is currently set to nearest neighbor, and I would like to change it to Trilinear or Cubic interpolation to smooth the image and remove the artifacts.
However, I have been unable to find where to adjust the interpolation settings in Workbench.
What I would like to ask:
Where are the interpolation settings located in Workbench 2.1.0? Could you provide a step-by-step guide on how to access and change them?
If you have any other guesses about what might be causing these artifacts (unrelated to interpolation), I would greatly appreciate any suggestions or advice.
Thank you very much for your time and for developing such a valuable tool.