Development Kit Startup > not working Win10.Arduino 1.8.8

[adriens]

After having applied steps of startup kit
Xkit_Development_Guide_For_Arduino_v10.pdf

I could not manage to make the demo run :

Sketch uses 16826 bytes (52%) of program storage space. Maximum is 32256 bytes.
Global variables use 1260 bytes (61%) of dynamic memory, leaving 788 bytes for local variables. Maximum is 2048 bytes.
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00
An error occurred while uploading the sketch

Any help would be greatly appreciated ad for now I'm stuck.

[omarcoaur3lio]

Hi,
To upload a sketch to the Arduino board (with the Xkit shield plugged into it), you must remove the P9 jumpers on the Xkit or disconnect you Xkit of the arduino.

[adriens]

Thanks, I'll try this approach 👍

[adriens]

@sgtmarcoaurelio : removing the P9 jumper did the job 🎆 👏 🙏
Thanks a lot for your help, I could instantly upload the code !