Button setting in orangepi 5 #99
Description
thanks for your works , I meet a problem ,when I set button in orangepi 5 . I don't know how to set pin number；
+------+-----+----------+--------+---+ OPI5 +---+--------+----------+-----+------+
| GPIO | wPi | Name | Mode | V | Physical | V | Mode | Name | wPi | GPIO |
+------+-----+----------+--------+---+----++----+---+--------+----------+-----+------+
| | | 3.3V | | | 1 || 2 | | | 5V | | |
| 47 | 0 | SDA.5 | IN | 1 | 3 || 4 | | | 5V | | |
| 46 | 1 | SCL.5 | IN | 1 | 5 || 6 | | | GND | | |
| 54 | 2 | PWM15 | IN | 1 | 7 || 8 | 0 | IN | RXD.0 | 3 | 131 |
| | | GND | | | 9 || 10 | 0 | IN | TXD.0 | 4 | 132 |
| 138 | 5 | CAN1_RX | IN | 1 | 11 || 12 | 1 | IN | CAN2_TX | 6 | 29 |
| 139 | 7 | CAN1_TX | IN | 1 | 13 || 14 | | | GND | | |
| 28 | 8 | CAN2_RX | IN | 1 | 15 || 16 | 1 | IN | SDA.1 | 9 | 59 |
| | | 3.3V | | | 17 || 18 | 1 | IN | SCL.1 | 10 | 58 |
| 49 | 11 | SPI4_TXD | IN | 1 | 19 || 20 | | | GND | | |
| 48 | 12 | SPI4_RXD | IN | 1 | 21 || 22 | 1 | IN | GPIO2_D4 | 13 | 92 |
| 50 | 14 | SPI4_CLK | IN | 1 | 23 || 24 | 1 | IN | SPI4_CS1 | 15 | 52 |
| | | GND | | | 25 || 26 | 1 | IN | PWM1 | 16 | 35 |
+------+-----+----------+--------+---+----++----+---+--------+----------+-----+------+
| GPIO | wPi | Name | Mode | V | Physical | V | Mode | Name | wPi | GPIO |
+------+-----+----------+--------+---+ OPI5 +---+--------+----------+-----+------+
Here is my setting, but it didn't works
gsmenu:
enabled: true
gpio:
# RuncamVRX
left: 3
right: 4
up: 6
down: 13
center: 15
# alternative
# center:
# chip: gpiochip3
# pin: 1
rec: 16
# Ruby